![]() That was easy, right? I like this cleaning process so much that I do it to new components.Įnjoy the excellent reliability you have provided for your computer simply by doing this. Press on the module carefully but firmly, and make sure they are seated correctly. You can tell by looking at the divider location in the slot and matching it to the RAM module. Reinstall the memory back into the RAM slotsīefore reinstalling the RAM modules, check that the modules and the slots are clear of dust or debris.Įnsure you have opened the clips on either end of the slots before attempting to reinsert the modules.Ĭheck to make sure that you have them orientated the correct way around. Please refer to my article: How do I know if my RAM slots are bad? To know more about identifying faulty slots. This is where I have noticed people making a mistake by overlooking some small bit of dust or debris and ending up falling back into one or more of the RAM slots. The tiniest little spec can wreak havoc on your system. Use a good light source, and make sure they are perfectly clean. Keep blowing them out until there is no debris left inside them. Clean out the RAM slotsĭo not use anything else but some compressed air to clean out the RAM slots. Do this before cleaning the eraser filings from the contacts. This helps loosen any extra eraser filings that could be trapped under the heat spreaders. Tip: I have also found an additional benefit to lightly tap the RAM modules against a clean flat surface along the bottom edge where the copper contacts are. Give the RAM a blow with compressed air to make sure there are no bits of debris or dust left on the contacts or under the heat spreaders. You must ensure that all the eraser filings or any eraser deposits have been cleaned off properly. This is a step that is very important to get right. Clean off the eraser filingsĪfter giving the contacts a good clean with the eraser, take a cloth and keep wiping them until it feels smooth or once you are convinced that there are no traces of eraser filings left. Turn the RAM module over and repeat the process on the other side. You will notice the first few strokes will most likely result in the eraser end becoming a bit dirty. Use the pencil eraser in short strokes, all of the contacts back and forth until the eraser end is clean. Lay the RAM module down on a flat, clean surface. It simply means you must be extra cautious when removing or installing RAM. If one is fixed and cannot move, it’s perfectly normal, as some motherboards are designed this way. Remove the case lid and remove the RAM from the slots by gently releasing the clips on either end of the slots. Unplug your computer from power and everything else to move it to an uncluttered work area.īefore touching any internal components, touch the case first to help reduce any built-up electrostatic charge you may have accumulated. Prepare a good enough workspace to remove the RAM It will make the job of cleaning them far easier. Remove the case if your computer is dusty inside before removing any RAM modules. It’s always best to keep those things away from such delicate surfaces. I do not recommend using any solvents or sprays when cleaning RAM. It has taught me that RAM doesn’t go faulty nearly as often as most would think. I have found that this method has reduced the amount of RAM replacement by over half. To outline the process, all we are going to do is clean the module’s contacts and the slots. Keeping your computer clean is one thing, but your RAM is so important to keep your computer stable and reliable. ![]() Tin of compressed air or an air compressor.Good cloth (With as little lint as possible).A good quality pencil eraser (Like Faber-Castell, for example).Important: Never touch RAM contacts with your fingers or any other card’s contacts for that matter. The same technique can be applied to all other RAM and add-in cards, even mini PCI express or M.2 modules. Reinstall the memory back into the RAM slots
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |